It should be very close to zero (0) ohms. Measure the resistance between the two units to verify there is a direct electricalĬonnection. Problem before continuing with any further installation of the HamLinkUSB™ RigĬontrol Plus module or any other computer or radio equipment.Īfter you have measured zero (0) volts between your computer and your radio, then Radio equipment, your computer or the electrical wiring in your building. If it is not zero (0) volts, you may have a ground problem with your Use a voltmeter to measure the voltage between your computer and your radio. HamLinkUSB™ Rig Control Plus module and your otherīefore connecting this cable assembly between your radio and HamLinkUSB™ RigĬontrol Plus module, check the ground connection between your computer and your This step will help prevent possible damage to the Please check with Timewave for additional cable assemblies.
MiniDin-8 Cable Assembly for CAT-enabled radios (Yaesu® FT-857, FT-817,ĭin-6 Cable Assembly for Yaesu® CAT-enabled radiosĤ conductor Cable Assembly, 3.5mm plug to stripped end There are several Timewave cable assemblies that may connect to your radio, theseĬI-V Cable Assembly for Icom® and Ten-Tec® radios Your computer now has the Timewave HamLinkUSB™ completely installed. The COM driver is now installed and your COM port should appear. Next, the wizard will restart for the COM port driver. The GREEN light inside of the HamLinkUSB will light up. The software signing dialog may appear as The Found New Hardware Wizard should appear. Manually uninstall the driver from the Device Manager and reconnect. If you are using XP, the Found New Hardware notify box should appear. If you are using Windows Vista or Windows 7, the Ready to Use notice will appear. If you get the restart dialog, click on “Restart Now” to reboot your computer.
If not, run U232VCPInstaller.exe from the CD.Īfter a minute, the Installation Successful dialog will appear. Insert the TIMEWAVE U232 USB to UART Drivers CD into your computer. If you have already done so, please unplug it before Windows Vista and the Windows logo are trademarks of the Microsoft group of companies. Windows and the Windows logo are trademarks of the Microsoft group of companies. © Copyright 2006-2010, Timewave Technology, Inc., All Rights ReservedĪll U232/HamLinkUSB Drivers are certified. DO NOT insert the HamLinkUSB module before installing the
0 kommentar(er)
